Instrument Functions
R&S
®
NGP800
62
User Manual 5601.5610.02 ─ 04
6.7
Advanced Features
QuickArb function
If QuickArb function of a selected channel is enabled, the respective channel voltage,
current setting and safety limit settings are disabled.
See
Chapter 6.1, "Setting the Channels Voltage and Current"
The QuickArb and EasyRamp are two functions which can be used to control the
waveform of voltage and current output.
6.7.1
QuickArb
The QuickArb function allows you to generate freely programmable waveforms which
can be reproduced within the
1. Press [Settings] key.
The R&S
NGP800 displays the device/channel menu window.
2. Select the required channel tab to configure QuickArb function.
The R&S
NGP800 displays the selected channel menu.
3. Select "Arbitrary" from the menu.
The R&S
NGP800 displays the "Arbitrary" dialog.
4. Select any of the rows to load or change the arbitrary file in the arbitrary sequence.
Up to eight arbitrary files with a maximum of 1024 data points can be loaded.
The R&S
NGP800 opens a dialog to select the source and file location.
5. Select the required source and file location.
6. Select "Select" to load the selected file.
The R&S
NGP800 loads the selected arbitrary file.
Advanced Features
www.allice.de
Allice Messtechnik GmbH
