Arbitrary and Function Generator
R&S AM300
E-1007.9922.12
6-168
Operating manual, 02/2005
6.2.4.5.5
Configuring Burst Mode
Note
The
function key is only available if the "Burst" gate function is
switched on ( 6-163).
Application
You can enter the number of signal periods for a burst and start Burst mode
( Figures, 6-164 and 6-165).
Setting the
burst periods
1.
In the
submenu
press the
function key
.
An entry field containing the currently applicable setting is displayed. The
default setting is "1".
2.
Enter a new value ( 5-55).
The permissible entry range for the burst period is:
1
≤
Burst Cycles
≤
65535
3.
Press the
ENTER key
The new setting is stored.
Switching
Burst mode
on/off
1.
In the
submenu
press the
function key
.
The function key is highlighted. After switching on, a burst is gen
erated
using the set number
of signal periods
.
2.
In the
submenu
press the
function key
.
The function key is
no longer
highlighted and Burst mode is switched off.
Delivering a
trigger signal to
the Sync output
1.
Select the "Trigger" setting as the synchronization source ( 6-140).
2.
Switch the appropriate Sync output on ( 6-142).
Summary of Contents for AM 300
Page 2: ...02 2005 ...
