R&S AM300
Amplitude and Frequency Settings
Operating manual, 02/2005
4-43
E-1007.9922.12
4 Getting
Started
This chapter
Chapter 4 uses a number of simple settings to illustrate how to operate the
R&S AM300.
For the following example, the initial setting for instrument is the default
setting (factory). This is set in the menu PRESET ( 6-191). The full default
setup is described in chapter 6.
Further
information
Chapter 5 contains an in-depth explanation of the basic operating steps, for
example selecting menus and setting parameters. The layout of the screen
and the information displayed on the screen are also described.
Chapter 6 describes all the R&S AM300‘s menus and the associated
functions in detail.
4.1
Amplitude and Frequency Settings
Introduction
In this example the
square
waveform is applied to the output CH1 [8] with a
frequency of 250 kHz and an amplitude V
pp
= 5 V and with a duty cycle of
20 %. The parameters are set up manually.
Steps in setting up
Perform the following steps:
1. Reset the R&S AM300.
•
Press the
key.
•
Using the
cursor keys select
from the bottom menu
bar.
•
Press the
key.
2. Select square waveform.
•
Using the
cursor keys select
from the bottom menu
bar.
•
Press the
key
.
•
Use the rotary knob to select the
Square
setting. Finish the selection
procedure with
3. Set the signal frequency at 250 kHz.
•
Stay in the
menu.
•
Press the
key.
•
Use the numeric keys to enter the value
. Finish the
entry with the
unit key.
Summary of Contents for AM 300
Page 2: ...02 2005 ...
