Setting Parameters
R&S AM300
E-1007.9922.12
5-56
Operating manual, 02/2005
Terminating
entries
3. a)
Press a
unit key
g.
MHz,
to
terminate the entry.
The R&S AM300 sets the value that has been set numerically using the
new
unit
. The entry window is closed.
b)
Press the
ENTER
key
The R&S AM300 sets the value that has been set numerically, but with
the
old
unit
. The entry window is closed.
Note:
If a parameter is unitless or always has the same unit, you can
terminate the entry with the
ENTER key or one of the unit keys.
c)
Press the
ESC/CANCEL key
The
old value
is
retained. The entry window is closed.
Invalid
parameter entry
If an invalid parameter is entered, the new value is rejected by the R&S
AM300 and an error message is issued:
•
Acknowledge the error message with the
ENTER key
parameter again within the indicated value range.
Note
When numbers are displayed, only the digit sequences 1 to 999 appear
before the decimal point. In other words, if the digit sequence <5000> and the
unit <kHz> are entered, <5 MHz> appears in the display. Trailing zeros will be
eliminated in the display area.
Summary of Contents for AM 300
Page 2: ...02 2005 ...