R&S AM300
Arbitrary and Function Generator
Operating manual, 02/2005
6-107
E-1007.9922.12
6.2.1.4.5 PULSE
Waveform
Application
You can set the following parameters for the
Pulse
waveform:
Selecting the
WAVE PARAM
submenu
1.
Select the
Pulse
waveform ( 6-72).
2.
In the
menu
press the
function key
.
The submenu is opened and the function keys [13] are assigned the
appropriate function.
Exit submenu
Set pulse period
( 6-108)
Set pulse width
( 6-108)
Select polarity of waveform
( 6-106)
Note
The
Pulse
waveform is always generated in both channels simultaneously
with the same period. If frequency coupling between the channels is off, you
can set a different pulse width in each of the two channels.
If either of the channels is changed from the
Pulse
waveform to a different
waveform, both channels are switched to the new waveform.
PULSE
WIDTH
PULSE PERIOD
Norm
POLARITY
Inv
Summary of Contents for AM 300
Page 2: ...02 2005 ...
