R&S AM300
Arbitrary and Function Generator
Operating manual, 02/2005
6-157
E-1007.9922.12
6.2.4.1
Selecting Trigger Mode
Note
The "Select trigger mode" setting can also be entered in the SWEEP menu (
6-150).
Application
Use the "trigger mode" function to set the Trigger operating mode. This
setting is used to set the trigger for the Sweep/Burst operating mode.
The trigger control affects the output of all waveforms. You can choose from
the following settings:
Free Run
No triggering takes place and the signals are output continuously.
Internal
The internal trigger generator is selected as the trigger source ( Figure,
6-158).
External
A signal at the external trigger input [26] is selected as the trigger source
( Figure, 6-158).
Manual
A once-only trigger event is executed by means of a keystroke.
Setting trigger mode
1.
In the
menu
press the
function key
.
A selection field containing specified settings is displayed. The default
setting is "Free Run".
2.
Use the
rotary knob
[11] to select a setting.
3.
Press the
ENTER key
[5] to close the selection field.
The new setting is stored.
Delivering a
trigger signal to
the Sync output
1.
Select the "Trigger" setting as the synchronization source ( 6-140).
2.
Switch the appropriate Sync output on ( 6-142).
Execute once-only
triggering
In manual Trigger mode:
•
In the
menu
press the
function key
.
A once-only trigger event is executed. The R&S AM300S AM300 then
waits for further manual trigger pulses. You may repeat this procedure as
often as you wish.
Summary of Contents for AM 300
Page 2: ...02 2005 ...
