R&S ENV4200
Remote Operation
User Manual 1107.2470.12 - 03
E-26
6
Remote Operation
The test path of the V-network to the test receiver can be selected manually using the
rotary switch or via remote control.
For remote control, the V-network is connected to the test receiver via a connecting
cable.
Fig. 11
Pin assignment for rear remote control connector (REMOTE CONTROL)
Table 1
Pin
Function
12
GND
14
Test path N
15
Test path L1
16
Test path L2
17
Test path L3
The test paths L1, L2, L3 and N are selected as shown in
Table 1
Pin 14
Pin 15
Pin 16
Pin 17
Selected line
L
H
H
H
N
H
L
H
H
L1
H
H
L
H
L2
H
H
H
L
L3
L level = 0 V to 0.4 V
H level = 2 V to 5 V
To activate remote control apply one of the pins 14, 15, 16 or 17 to GND (pin12).
