R&S OSP
Getting Started
R&S OSP Panel Functions
Quick Start Guide 1505.3896.62 - 14
39
3.3.3 Changing the IP address with R&S OSP Panel
The OSP Panel supports the setting of the user defineable static IP address. Please
note that this function is supported in OSP Panel version 2.00 onwards.
Depending on the two possibilities of the LAN configuration mode with the OSP, the
following menus are offered .
3.3.3.1 LAN configuration mode DHCP_AUTO
See
chapter 2.9.1.1
for more information on the LAN configuration mode.
Select the menu function >Configure >TCPIP and the following dialog is opened:
The upper half of the dialog shows the last used DHCP address and the actual static
IP address.
A new user defined static IP address can be entered together with a subnet mask.
Changing of IP address
Whenever the IP address is changed via the OSP Panel and the previous one was
used for OSP Panel communication, you must disconnect the OSP Panel, change the
address in the OSP Panel menu and connect to the device again.
The OSP Panel outputs a corresponding message to the operator when changing the
static IP address.
Summary of Contents for OSP-B011
Page 132: ......
