R&S OSP
Getting Started
Path Configuration in virtual mode
Quick Start Guide 1505.3896.62 - 14
66
3.5.3 Remote Control Setting of the Path Configuration
Once the required path configurations are stored in the R&S OSP, they are available
by remote control applications like the R&S EMC32 software.
The advantage to make use of the OSP path configuration utility is:
●
The switching is called by logical name from the external application (for example
EMC32 software). Using the logical name, the external application does not need
to know the R&S OSP hardware configuration.
●
If the hardware configuration has to be changed, only the path configuration inside
the R&S OSP must be adapted. The external application does not need to be
changed.
For the above examples, the following strings are to be sent to the R&S OSP:
ROUTe:CLOSe
“Path_PA1”
ROUTe:CLOSe
“Path_PA2”
ROUTe:CLOSe
“Path_PA3”
Further information on remote control functions and on applications together with the
R&S EMC32 software are to be found in the operating manual.
3.6 Path Configuration in virtual mode
With OSP Panel version 2.57 onwards, you can define a path configuration in virtual
mode. The advantage of this method is the possibility of preparing any path
Summary of Contents for OSP-B011
Page 132: ......
