R&S OSP
Instrument Functions
Module Functions
Quick Start Guide 1505.3896.62 - 14
89
Interface logic
Relay drivers
I
2
C memory
Module OSP-B106
Interface
connector
To OSP frame
(cable W5 or 6 or 7
NO
NC
C
NO
NC
C
NO
NC
C
NO
NC
C
NO
NC
C
NO
NC
C
K1
K2
K3
K4
K5
K6
Figure 5-22: Block Diagram Module R&S OSP-B106
When the module R&S OSP-B106 is configured within the R&S OSP, a manual operation
of the module can be performed via the OSP Panel. See
chapter 3.3.6
For remote control operation and for details on the connector pin assignments, refer to
the operating manual.
The module OSP-B106 has a double width. Therefore only one module can be
installed in one R&S OSP frame. If more than one module is required, the extension
unit R&S OSP150 must be used. For further information on the extension unit
R&S OSP150 refer to the operating manual.
The description above also applies to the following R&S OSP modules that have a
similar relay configuration:
Option
Relay configuration
OSP-B132
6 x SPDT relay with N-Connectors, 12 GHz
5.2.6 DC MUX Module R&S OSP-B108
The module R&S OSP-B108 is a four pole one to six multiplexer for DC.
It is controlled equivalent to first Relay K11 of R&S OSP-B102.
Figure 5-23: Module R&S OSP-B108
The R&S OSP-B108 module is supplied with power and controlled from the R&S OSP
via a single connector on the R&S OSP-B108 printed circuit board.
Summary of Contents for OSP-B011
Page 132: ......
