R&S OSP
Instrument Functions
Module Functions
Quick Start Guide 1505.3896.62 - 14
97
Figure 5-35: Block diagram Module R&S OSP-B126
When the module OSP-B125/126 is configured within the OSP120, a manual operation
of the module can be performed via the OSP Panel. See
chapter 3.3
For remote control operation refer to the operating manual.
The OSP-B125/126 is a three-slot module. Within one OSP120 only one module of this
type can be installed.
If more than one OSP-B125/126 are required, the extension unit OSP150 must be
used. For further information on the extension unit OSP150 refer to the operating
manual.
5.2.11 Module R&S OSP-B114 for EMS application
The module R&S OSP-B114 is intended for applications in small or medium systems
for Electromagnetic Susceptibility (EMS). The module fulfills the following tasks:
●
Switching of the output of two power amplifiers to one or two transmit antennas (or
other kind of transducers).
●
Providing the circuitry for an interlock loop with the following functions:
─
monitoring a interlock loop and read/display the actual status
─
power down external amplifiers depending on interlock status
─
disconnect the signal generator from power amplifier (if they cannot be
powered down) depending on interlock status
●
Four output lines. Can be used to control the polarization of the transmitting
antennas
●
Four input lines
Summary of Contents for OSP-B011
Page 132: ......
