Functions
R&S
®
OSP
186
User Manual 1178.7100.02 ─ 05
mand
, which is equivalent to the button "Save As New
Path".
When you click this button, a dialog opens to let you enter a name for this path. For the
path name, only the characters available in the virtual keyboard are permitted. You can
quit entering the name with the cancel button or confirm the entered name with the
OK button . When you click OK, the new path entry is added with its name at the top
of the list of paths.
To move the entry to a different position in the list, use the "Up" and "Down" buttons
shown in
. These buttons are only available, if no relays and channels are
selected.
Hence, first complete creating your path definitions. Once you do not need the selec-
tion of relays and channels any more, use the button "Remove path selection" (descri-
bed below, equivalent with "Deselect All").
Then click the
button to rearrange your new paths in the list of paths.
The button
"Show as List"
displays a path definition in the syntax shown above (see
"Save As New Path"). If you have defined a path that consists of one relay, only, the
string that represents this path can be as short as "
(@F01M01(0102))
", for example.
For each additional relay or output channel used in the definition, a similar string is
added, separated by a comma.
See also
When you close this dialog, your selection is still available for defining a new path.
The button
"Deselect All"
(also labeled "Remove path selection") disables all selec-
tions of relays and output channels. When you click this button, all selected relays and
output channels are immediately deselected, but their states remain unchanged. Also,
the selection indicator in the top right corner of the dialog is deactivated, and the func-
tion bar "Manage path selection:" disappears.
Path Switching
