Getting Started
R&S
®
OSP
50
User Manual 1178.7100.02 ─ 05
The software uses M01, M02, etc. instead of RS01, RS02, etc., as it cannot detect a
module's mounting position. It detects only to the module bus connector on the mother-
board, to which a module is connected.
Hence, a module information dialog addresses a module by its module bus connector,
for example, "Module Connector: M01".
In a factory configuration, the correlation of slot positions and module bus connectors
follows the scheme in
. If you mount modules yourself, we recommend that
you adhere to the same correlation.
The positions of the front and rear slots in the different switch unit models are also
shown in
Chapter 2.2.1, "Front Panel View"
Mounting a Module
