Functions
R&S
®
OSP
214
User Manual 1178.7100.02 ─ 05
Remote command:
CONFigure:FRAMe:ADD
CONFigure:FRAMe:INSert
CONFigure:FRAMe[:DEFine]
Delete
The "Delete" button deletes this secondary switch unit from the list of frames.
When you click the button, the firmware brings up the message "Do you really want to
delete the configuration of secondary device Fxx?" (where
Fxx
is the frame ID).
Confirm with "OK" or "Cancel" the deletion.
Remote command:
CONFigure:FRAMe:DELete
CONFigure:FRAMe:DELete:ALL
Edit Secondary
The button with the pencil icon opens and closes a field for defining or modifying this
switch unit's "Address".
To edit the address, click in the field. For editing, you can use the on-screen keyboard,
an external keyboard connected to the switch unit, or a keyboard connected to your
computer, when you use the R&S
OSP in a LAN. The name editor accepts the key-
board shortcuts [Ctrl]+[x] for "cut", [Ctrl]+[c] for "copy" and [Ctrl]+[v] for "paste".
You can quit editing with the cancel button or confirm the edited name with the OK
button .
Address: ← Edit Secondary
Not available for the primary switch unit, and not available in
.
Specifies the IP address, as described in
Also, you can enter a hostname in this field, if you adhere to the following rules:
●
Letters and numbers are permitted
●
Single dots and single or multiple hyphens are permitted. However, you must use
at least one letter or number ahead of each dot / each group of hyphens
and
after
each dot / each group of hyphens.
●
Other (special) characters are not permitted
●
You can use a maximum of 63 characters
5.4.5
Configuration Context Functions
The configuration context functions are grouped with the "General", "Trigger", "Net-
work" or "Interconnection" tabs, respectively. You can select either of the following:
●
"Configuration" >
"General"
view > "Context Menu"
–
–
●
"Configuration" >
"Trigger"
view > "Context Menu"
–
Configuration
