Preparing for Use
R&S
®
TSME-Z3
10
Getting Started 1519.0994.02 ─ 02
3
Preparing for Use
Risk of device damage due to environmental conditions
The R&S
TSME-Z3 was designed to provide a protected environment for
the measurement setup. However, observe the allowed environmental con-
ditions concerning temperature, humidity and mechanical stress described
in the R&S
TSME-Z3 data sheet and the general safety instructions to avoid
damage to the devices.
Two fans are built in in the R&S
TSME-Z3 backpack. Ensure that all fan
openings on both sides of the backpack are unobstructed and the airflow
perforations are unimpeded.
..................................................................................... 10
Completing the Pre-Configured Measurement System
...................................16
Supplying Power and Switching the System On and Off
................................ 17
3.1
Setting up the System
Unless pre-configuration was explicitely ordered, perform the procedure
If a mobile device mounting kit is also available and not mounted in the factory,
perform the procedure
"To mount one or more mobile devices on the system unit"
To mount one or more R&S
TSMEs on the system unit
1. For two stacked R&S
TSMEs:
Setting up the System
