Getting Started
R&S
®
TSME6
16
User Manual 4900.0033.02 ─ 06
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate the
product. The EMC class of the product is given in the data sheet.
●
Class
B equipment is suitable for use in:
–
Residential environments
–
Environments that are directly connected to a low-voltage supply network that
supplies residential buildings
●
Class
A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and radi-
ated disturbances. It is therefore not suitable for class B environments.
If class
A equipment causes radio disturbances, take appropriate measures to
eliminate them.
3.1.4
Connecting to power
This section describes how to connect the R&S TSME6 to a power supply unit.
3.1.4.1
Connecting to a vehicle DC power supply via cigarette lighter
The R&S TSME6 is delivered with a 12 V DC power supply cable with a cigarette
lighter connector.
1. Check the rating of the vehicle DC power supply. It has to be 12 V.
2. Connect the 4-pin connector to DC IN.
3. Connect the cigarette lighter adapter to the 12 V outlet of the vehicle.
3.1.4.2
Connecting to the vehicle power supply via terminal
To connect vehicle power supply via terminal
1. Demount the cigarette lighter adapter from the cable.
2. Connect the open ends of the cable to the DC supply.
Ensure that the polarity is correct. (see
Preparing for use
