Getting Started
R&S
®
TSME6
35
User Manual 4900.0033.02 ─ 06
● If the firmware version required by the application is available on the R&S
TSME6, but was not used for booting, the application reboots the R&S TSME6
using the required firmware version. Then the application establishes a connec-
tion to the R&S TSME6.
● If the firmware version required by the application is not yet available on the
R&S TSME6, the application uploads the required firmware version to the R&S
TSME6 (this may take about one minute). The application reboots the R&S
TSME6 using the required firmware version, then establishes a connection to
the R&S TSME6.
● If the firmware version required by the application is not yet available on the
R&S TSME6, and all three storage spaces for firmware are occupied by other
versions, the application must do the following:
a) Clear all storage space for firmware versions on the R&S TSME6 (this may
take about one minute).
b) Upload the required firmware version to the R&S TSME6 (this may take about
one minute).
c) Reboot the R&S TSME6 using the required firmware version.
d) Establish a connection to the R&S TSME6.
3.2
Instrument tour
3.2.1
Front panel view
The front panel of the R&S TSME6 does not provide any connectors or control ele-
ments for operation.
Behind the right side of the rear panel (with the ventilation openings), 4 status LEDs
are located. These LEDs display the following states:
●
LEDs ON: R&S TSME6 ready for operation, RF-PLLs initialized correctly
●
LEDs OFF: R&S TSME6 is off or RF-PLLs initialized not correctly
If the fans are off (temperature on the controller board < 60°
C), the LEDs are partially
covered by the fan blades.
Instrument tour
