Configuring the R&S TSME6
R&S
®
TSME6
51
User Manual 4900.0033.02 ─ 06
Figure 6-2: Tab "Network Configuration"
Applying changes to the LAN configuration
Changes to the IP address configuration in the R&S
TSME Device Manager are only
applied when you select the "Accept Network Changes" button. The reconfigured R&S
TSME6 is then accessible only via the new IP address.
6.1.3
Installing and managing software license keys - "Options"
All new devices are preconfigured and specified technology and band options are
already installed. Only if you obtain additional software options later, you have to
enable the options with the corresponding software license keys.
License keys are shipped as a printed "License Keys List". Advance deliveries may
consist of a PDF file. Unregistered software licenses can be downloaded from the
Rohde & Schwarz website (
https://extranet.rohde-schwarz.com/service
). For details,
see the "Installation Instructions for Options".
(Note: previously, license keys were shipped as
.xml
files.)
Prerequisites to install software license keys
To install a software license key, the following conditions must apply:
●
PC/notebook is connected via Gbit LAN adapter, with "Jumbo Frames" (9 kB)
enabled
●
The (registered) software license key must be available
Software license keys are installed using the "R&S
TSME Device Manager" ("Options"
tab).
Using the R&S TSME device manager