Configuring the R&S TSME6
R&S
®
TSME6
54
User Manual 4900.0033.02 ─ 06
Example:
An R&S TSME6 is configured with band option TSME-K2B (2 bands measured simul-
taneously). During the last measurement, the R&S TSME6 was used to perform mea-
surements in 900 MHz and 1800 MHz bands. For the next measurement, the R&S
TSME6 can still only be used in 900 MHz and 1800 MHz bands, unless you change
the band configuration using the "R&S
TSME Device Manager".
The band configuration is defined in the "Band Configuration" tab of the "R&S
TSME
Device Manager".
Select the bands that are to be scanned by the R&S TSME6 in the "Band Table".
Which bands are available is independent of the installed
technology
options; all instal-
led technologies can be scanned in all configured bands at the same time.
The
number
of bands available for selection depends on the installed band options.
Figure 6-4: Tab "Band Configuration"
The current band configuration for the selected R&S TSME6 is displayed for reference.
It remains active until you select the "Accept Band Changes" button.
Using the R&S TSME device manager
