Getting Started
R&S
®
TSME6
22
User Manual 4900.0033.02 ─ 06
c) Switch to the "Advanced" tab.
d) Select the "Jumbo Frames" property and the "Value":"9014 Bytes".
Note:
This setting may cause problems in Windows, but it is an important pre-
requisite for correct operation of the R&S TSME6.
See
"Does the host provide a Gbit LAN connector and support 9k jumbo
10. Close the control panel, reboot the host PC and check if the connection can be
Chapter 7.1, "Guide to solve instrument connection
If your firewall is active, make sure that it is configured as described in
Firewall configuration
The firewall can be turned off on the LAN interface or on with all the mandatory config-
urations.
If your firewall is active, make sure that your program is allowed to communicate
through the firewall. Following ports should be available:
●
RxPort (TSME6->PC): Port 17476
●
TxPort (PC->TSME6): Port 5140 and 16962
Also, the following parameters must be configured to decide if a specific program is
allowed to pass the firewall.
●
Multicast IP address for TSME:
224.17.4.76
●
Multicast Address for TSME6:
239.192.1.7
●
IP-Address of TSME6 has to be allowed as well:
192.168.0.2
(example)
Note:
In "full auto-IP" operating mode, the IP address generated for the R&S
TSME6 has to be allowed.
●
Allow UDP Protocol
Preparing for use
