47 / 207 - EN -
10.
Notes on operation
10.1.
Splash pan stopper
NOTE
The stopper should always be in the drain of the splash pan.
In addition, a collecting vessel should always be positioned under the drain in order to
avoid damage to the floor or the furnishings of the installation room.
The overflow hose must not be completely sealed. Only use the overflow stopper
provided.
The manufacturer assumes no liability for damage to the furnishings and equipment in
the installation room due to material that has leaked.
10.2.
Magnetic holder for the supplied accessories
The supplied accessories, like the 3 Allen keys and the 2 drive screws for a wooden throwing batt, can be positioned
on the magnetic strips on the inside of the lower housing.
The stopper supplied has an overflow. I.e., the material can rise to a certain
point in the splash pan when the stopper is inserted and then drains over the
stopper into the drain.
Be careful not to collect too much material in the splash pan. If
necessary, remove any accumulated material from the splash pan
while you are working.
Summary of Contents for HMT 600
Page 207: ...20211105 01 ...
