LABEL
TYPE OF TEXTILE
Do not iron this article
.
Synthetics, Nylon, Acrylics, Polyester, Rayon
..
Wool, Silk
…
Cotton, Linen
Insert the main plug into the wall socket. The indicator light will turn on.
When the indicator light goes out you may start ironing.
If you set the temperature control to lower setting after ironing at a high temperature. it is not
recommended to iron before the pilot light switches on again.
WATER TANK FILLING
Unplug the iron before filling the water tank.
Hold the steam iron in horizontal position.
Slowly pour water through the water inlet.
Do not fill higher than mark on the water tank, in order to avoid spilling out of water.
NOTE:
Your steam iron is designed to use tap water, However, if the water is very hard, it is
advisable to use distilled water.
The water tank should be emptied after each use.
NOTE:
if you empty the water tank after the steam iron has cooled down, set the steam iron
upright position on its heel rest, plug it in and set the temperature control dial to the maximum
position, heat for 2 minutes. Unplug the steam iron from the power supply.
SPRAYING
As long as there is enough water in the water tank, you may use the spray button at any
temperature setting during steam or dry ironing.
Press the spray button several times to activate the pump while you are ironing.
STEAM IRONING
Set the variable steam control to the desired position.
CAUTION:
Avoid coming in contact with ejected steam.
