- 28 -
BIOS
USB hardware delay and time-out
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and
interrupt transfers.
Options:
1 sec, 5 sec, 10 sec, 20 sec
(default)
Device reset time-out
Use this item to set USB mass storage device start unit
command time-out.
Options:
10 sec, 20 sec
(default)
, 30 sec, 40 sec
Device power-up
delay
Use this item to set maximum time the device will take before it
properly reports itself to the host controller.
Options:
Auto
(Default): ‘Auto’ uses default value: for a root port
it is 100 ms, for a hub port the delay is taken from hub
descriptor.
Manual
: Select
Manual
you can set value for the following
sub-item: ‘
Device Power-up delay in seconds
’, the
delay range in from 1 to 40 seconds, in one second
increments.
Summary of Contents for QSM-622E
