9
You can change the “Standby” mode brightness by pushing the button
to move the frame
to the “STAND-BY” position. You can then adjust the brightness by pushing the same
and
keys.
To finish the programming wait for 10 seconds without pressing any buttons.
2. PROGRAMMING ThE T SERIES TOwEL RAIL
IMPORTANT NOTICE: PLEASE READ THE INSTRUCTIONS FULLY BEFORE STARTING THE
PROGRAMMING TO ENSURE A GOOD UNDERSTANDING OF THE PROCESS.
2.1. Adjusting the time and day
In order to adjust the time and day of the week, please follow the steps below. First we choose
the hour, then the minutes, then the day of the week:
To enter the time and day adjust mode, please ensure that the screen shows an symbol (if
the screen shows an symbol, press
briefly to switch to manual operation) and press
and hold for 3 seconds the
button.The hours will start flashing.
Select the hour using the
and
buttons to move the hour up or down.
Press
once and the minutes will start to flash.
In the same way as with the hours, use
and
to increase or decrease the minutes to
select the correct time.
Once the minutes are correct press
again so that the day flashes.
This represents Monday. With the
button we can advance through to day 2 (Tuesday), day
3 (Wednesday) etc. until we reach the required day. Press
again to confirm the day and
once more
to leave the time and date adjust mode.
2.2. Programming the towel rail
It is possible to programme the towel rail using the control panel.
In order to start the programming please ensure that the screen shows automatic mode with
the symbol .
If the screen shows an symbol, please press the
button to change modes.
By pressing and holding
for 3 seconds the button we enter programming mode.
