ROJEK Co.
PF 300L,°-LE, PF 350, -E
12
4.5 Safety regulations for maintenance
Get up manual instruction for machine maintenance men in all points before starting
any maintenance work.
- Before beginning with maintenance works: Switch off
always the main switch and lock it or disconnect the ma-
chine by towing off the plug from socket. Hererwith you
avoid an occassional starting of machine by chance by
another else person.
- A qualified person must practise maintenance works on
electric parts.
- The machine is not disconnected from voltage when it
gets stopped. Switch off always the main switch and lock
it or disconnect the machine by towing off the plug from socket.
- Do not clean the machine or its peripheral system if machine is completely out of run
as long as the main switch is not switched off or the plug towed out from the mains socket.
- Keep your fingers distant from belts and belts pulleys and from chains and chain wheels.
Before exchange of machine electric parts – switch off the main switch, lock it or discon-
nect the machine by towing off the plug from the socket. For replacing of defected pro
ducts use those consistent with specification of originals.
- Do not remove or do up blocking of limit switches or other safety components.
- Keep always tidy the space for maintenance including your working place.
- Maintenance works must be practised by qualified
personnel in tune with producer´s instructions.
- Read through all the instructions manual for maintenance
men patiently.
- For an exchange of parts and needy subjects – ensure in advance equal ones with the
original type or corresponding with the norms.
- Use only specified brands of lubricant (oil or grease) or with these equal ones.
- Do not use compressed air for machine cleaning or removing of wood chips.
- Control results of maintenance in presence of a responsible person.
4.6 Safety regulations for working place
- Ensure always sufficient working space and free access
to the machine and its peripheral device.
- Place the tools and other obstacles at a place for this
intended and remote from the machine.
- Ensure sufficient lighting in working space that will not throw shadows or cause a strobo-
scopic effect. Hygienic norms indicate 500 lx for minimal lighting for safe and quality work.
- Never lay tools or other subjects onto working tables or coverings.
