ROJEK Co.
PF 300L,°-LE, PF 350, -E
24
The height of scoring saw blade is
adjustable by help of a screw with a
hand star (D) and with the arresting nut
(E). After releasing of the arresting nut
(E) - the scorer lifts up when turning the
hand star (D) with the screw to the right
and vice versa. Tighten up the arresting
nut (E) after setting the required height
of the scorer.
A maximal height of blade jags
overreaching must not exceed 3
mm!
9.5 Adjusting of lengthwise rule
Required width of cut gets adjusted by
sliding of lengthwise rule (A) alongside
the leading rod (B). The position is
secured with the tightening lever (C).
For a more accurate adjusting you can
use a fine shifting by help of yoke with
a nut (D) and an arresting screw with
manual star (E). The rule (A) can be
ejected after releasing of arresting
screws (F).The L profile can be wound
when sawing narrow parts. The width
of cut is showed at the measure.
Supporting square can be laterally
moved after releasing of fixing screws.
The measure can be so adjusted to a
correct worth related to jags expansion
of used saw blade.
Parallelity adjusting
Parallelity of lengthwise rule (A) with
saw blade (B) gets adjusted by a
position changing of the rule leading
rod by release or insertion of carrying
spacers (D) in place of fixing the rule to
cast iron table. After release of
screws (C) and that of safety nuts you
can rotate with the spacer. Screw it in
or out to a new dimension of distance.
The new position of rod must be fixed
by two nuts in the edging of table
extension in place of attachment of rule to table extension.
The rule divergence, set by producer, is c. 0,1÷ 0,2 mm/ 1m
.
