ROJONE Pty. Ltd – 61 Aero Rd, INGLEBURN NSW 2565 AUSTRALIA
TEL +61 02 9829 1555 FAX 02 9605 8812 EMAIL sales@rojone.com.au
24
Apply silicon grease to the Outer Boot along the Inside Rim. The silicon grease should form a bead completely around
the top of the inside rim, particularly in the CORNERS. It is important for a good seal to have plenty of silicon grease
in the corners.
Slide the Outer plastic boot over the box and over the Inner plastic boot all the way until the Desiccant Bag comes in
contact with the Rear Panel.
The Outer plastic boot should now overlap the Inner plastic boot and the Silicon Grease should form a seal between the
2 boots.
Take the 2 large cables ties and carefully apply them around the overlapping boots and ensure that they are not over
tightened. The cable ties must NOT pinch the boot. Apply the 3 smaller cable ties to each of the cable entry boots, do
not over tighten. Cut and remove excess cable tie ends.
