OPERATION
1.
Operation Controls
WARNING - Do not attempt to start or operate the engine until completely familiar with the
location and use of each control necessary to operate this vehicle. The operator must know how
to stop tins machine before starting and driving it.
Throttle
The right foot pedal is the throttle that controls the Go-Kart speed As the engine speed
increased above idle, the clutch automatically engages and moves the vehicle forward. To
disengage the clutch at any time, allow the throttle to return to the idle position, (See picture
1).
Brake
The brake is located on the left side of the kart (See Picture 1). Applying pressure to the
pedal draws the brake caliper around the brake pump at the rear wheel and slows or stops the
kart,
Start engine
Insert the key into key-switch, turn the key clockwise, release the key when the engine starts.
The engine will warm up within 5 minutes and the engine choke will close automatically and
operate at normal RPM (Warning: Don't crank starter longer than 5 seconds at one time).
Engine stop button
Important: stop button test. Before driving
this vehicle, test the Engine Stop Button to
assure that it is operating properly. With the
engine running, push and hold the Engine Stop
Button for two seconds for the engine to shut down.
