1.How to change gear oil:
C. REFILLING BRAKE OIL:
(DISK BRAKE)
●
Remove drain plug to allow the oil to flow out. When
engine is warm, it is easier to remove oil flow out.
●
Turn the handle bars until the brake fluid level
●Re install drain plug.
in brake fluid storage tank becomes horizontal.
●Fill with new gear oil. (110c.c.)
●
Remove the tank cover and seal.
●Tighten up filler nut.
●Fill with
brake fluid a little above the "low" mark; then replace
●Check for leaks.
cover and screws.
NOTICE:
Riding in the following conditions will require more frequent
●Rea
ssemble the seal, tank cover, and upper handle bar cover.
gear oil changes:
WARNING:
*Always riding in dusty conditions. (Dirt and Gravel Roads.)
●
Use only the specified brake fluid, otherwise, the rubber seal
*Riding for long distances.
can be distorted leading to oil leakage, and brake failure.
*Riding in areas with high humidity and damp areas.
●Do not mix brake fluid with any other oil or fluid.
●It will cause chemical reaction and lead to brake failure.
●Do not let water penetrate the main cylinder otherwise
brake failure could occur.
●
The painted surfaces and plastic parts could be damaged by the
brake fluid. In case of spills clean thoroughly and promptly.
●Constant loss of fluid should be checked by a trained professional.
24
