Rokid RG201, User Manual

FCC statement

：

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device has also 
been tested against this SAR limit. This device was tested for typical body-worn 
operations with the back of the handset kept 0mm from the body, and also tested for 
in-front-of the face operations with the back of the handset kept 15mm from the head; To 
maintain compliance with FCC RF exposure requirements, use accessories that maintain a 
0mm separation distance between the user's body and the back of the handset, and a 
15mm separation distance between the user's head and the back of the handset. The use 
of belt clips, holsters and similar accessories should not contain metallic components in its 
assembly. The use of accessories that do not satisfy these requirements may not comply 
with FCC RF exposure requirements, and should be avoided.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 
two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may 
cause
undesired operation.

5G WIFI statement
The device is restricted to indoor use when operated in 5150MHz~5350MHz to reduce 
the potential for interference.

NOTE: This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to part 15 of the FCC Rules.  These limits are designed to provide 
reasonable protection against harmful interference in a residential installation.  This 
equipment generates uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio 
communications.  However, there is no guarantee that interference will not occur in a 
particular installation.  If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following 
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
- This device and its antenna(s) must not be co-located or operating in conjunction with 
any other antenna or transmitter.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by 
unauthorized modifications to this equipment. Such modifications could void the user’s 
authority to operate the equipment.