13
ROL | ERGO Sweden W: www.rolergo.com P: +46 36 36 88 80
Pinch protection (optional)!
The ECS is equipped with an intelligent software pinch protection. During loo ration the
currents to each connected motor is continuously measured and any variation of current
is evaluated about 50 times each second! If a collision is detected system will immedia-
tely stop and back off about 2 cm!
IMPORTANT!
Make sure to remove the blocking item causing the pinch before trying to
operate the table again. Failure to do so may cause injury to user or equipment.
3.1.1 Upward desktop movement
This function enables you to adjust the desktop upwards. To
change its position, proceed as follows: Press the desktop up
button. Keep pressing the button until the required desktop
height is reached.
NOTICE
The desktop will continue moving upwards until you release the button or the maximum
height is reached
3.1.2 Downward desktop movement
This function enables you to adjust the desktop downwards. To
change its position, proceed as follows: Press the desktop down
button. Keep pressing the button until the required desktop
height is reached.
NOTICE
The desktop will continue moving downwards until you release the button or the mini-
mum height is reached.
3.2 Advanced functions, Manuel reset
In case of exchanged parts (ie motor, electronics) there could be a need of a manual
reset so columns and handsets correspond to each other. Even poor connection of the
cables could create a need of resetting.
