ROL | ERGO Sweden W: www.rolergo.com P: +46 36 36 88 80
6
13. In the event of a malfunction (e.g. if the control unit keeps adjusting the desk becau-
se a movement button has jammed), please unplug the unit immediately.
14. Do not expose the power supply, handset or other electrical device to water or other
liquids including moisture, drips, splashes or spills. Only clean electrical device with
a dry cloth.
15. Do not operate the power supply, handset or other electrical device in a potentially
explosive atmosphere. Do not operate where aerosol spray products are being used
or where oxygen is being administered.
16. Do not use the desk with it has been dropped or damaged. Contact the manufactu-
rer for examination or repair.
17. It is not allowed to connect self-constructed products to the power supply, handset
or other electrical device. To prevent damage, use only components recommended
by the manufacturing company.
WARNING
Risk of injury, or death:
1.
During the raising or lowering of the table there exists a risk of squeezing or
pinching between the moving desktop and fixed objects.
2. The necessary safety margins depend on the greatest type of injury risk that can
be predicted. Where possible small pinch points exist (i.e. fingers) use at least 2,5
cm (1 inch) safety margin and for body or head (especially where children may be
present) use a minimum of 40 cm (16 inch) count from the floor or from their top of
the table feet if that is relevant
3. During the lowering or rising of the desktop, the operator must ensure that no per-
son or object risk being harmed by the operation.
4. This tag (as right) should be located on the table
during the initial installation.
5. Keep children away from moving parts and under-
neath the table.
6. The intended use of the table is adjusting a work
surface between sitting and a standing position. The
table is not designed for other uses.
7. The table must only be operated while in an upright
position and must under no circumstances be
operated while upside down.
8. The table must not be overloaded. The maximum
allowable load is shown on the power supply label.
