Phrase Setting Contents Request
Function 1: Phrase setting contents request
Syntax:
stxQQ:a;
(RS-232C, Command format: Type 2)
Syntax:
QQ:a
(Telnet, Command format: Type 2)
a: Phrase number
Note:
The phrase settings for the specified phrase number will be output.
The value of the Phrase Output Counter (described below) will not change.
(* refer to 4.4.1 the RU command)
Function 2: If the phrase number is not specified as a parameter, the AR-3000SD will output the
phrase settings for automatically incremented phrase number by the Phrase Output
Counter.
Syntax:
stxQQ:;
(RS-232C, Command format: Type 2)
Syntax:
QQ:
(Telnet, Command format: Type 2)
Note:
The incremented value will skip phrase numbers which are not recorded yet, and will be
up to the next recorded phrase number.
If the QQ command is used to request output even after the setting information of the
last phrase has been output, the AR-3000SD will output “ER:101”.
In the case of a Pattern Phrase, you must use the separately described 3Q command to
request output of the settings. (* refer to 3Q command)
* About the Phrase Output Counter
The AR-3000SD contains the Phrase Output Counter.
The maximum value of this counter is the maximum phrase number of each card.
The counter is reset (i.e., to the lowest phrase number) by the AQ command.
So you can request each phrase settings of all phrases in the card by sequentially using
the QQ command’s function 2 after resetting the counter.
3Q
Pattern Phrase Setting Contents Request
Function: Pattern Phrase setting contents request
Syntax:
stx3Q:a;
(RS-232C, Command format: Type 2)
Syntax:
3Q:a
(Telnet, Command format: Type 2)
a: Pattern Phrase number
Note:
This is a request for when the phrase type is pattern phrase.
(* refer to 4.4.1 PS command)
GQ
Song Phrase Setting Contents Request
Function: Song Phrase setting contents request
Syntax:
stxGQ:a;
(RS-232C, Command format: Type 2)
Syntax:
GQ:a
(Telnet, Command format: Type 2)
a: Song Phrase number
Note:
This is a request for when the phrase type is song phrase.
(* refer to 4.4.1 SS command)
AR-3000SD (Ver.1.00) Command Reference - 55
