TQ
Time Stamp Request
Function 1: Time Stamp request
Syntax:
stxTQ:a;
(RS-232C, Command format: Type 2)
Syntax:
TQ:a
(Telnet, Command format: Type 2)
a: Phrase number
Note:
Output the recording start time information for the specified phrase. (Refer to 4.4.1 TI
Command.) The AR-3000SD outputs an ER command for phrases in which time
Information is not recorded.
Function 2: Time Stamp request
If the phrase number is not specified as a parameter, the AR-3000SD will output the
Time Stamp information for automatically incremented phrase number by the Phrase
Output Counter.
Syntax:
stxTQ:;
(RS-232C, Command format: Type 2)
Syntax:
TQ:
(Telnet, Command format: Type 2)
Note:
The incremented value will skip phrase numbers which are not recorded yet, and will be
up to the next recorded phrase number. If the TQ command is used to request output
even after the setting information of the last phrase has been output, the AR-3000SD will
output “ER:101”.
CQ
Card Setting Contents Request
Function: Card setting contents request
Syntax:
stxCQ:a;
(RS-232C, Command format: Type 2)
Syntax:
CQ:a
(Telnet, Command format: Type 2)
a: Card in slot
0 Card in slot A
1 Card in slot B
2 Card in slot C
3 Card in slot D
Note:
refer to 4.4.1 CS command
MQ Card Remaining Capacity Request
Function: Card remaining capacity request
Syntax:
stxMQ;
(RS-232C, Command format: Type 1)
Syntax:
MQ
(Telnet, Command format: Type 1)
Note:
refer to 4.4.1 CR command
YQ
System Setting Contents Request
Function: System setting contents request
Syntax:
stxYQ:a;
(RS-232C, Command format: Type 2)
Syntax:
YQ:a
(Telnet, Command format: Type 2)
a: Card in slot
0 Card in slot A
1 Card in slot B
2 Card in slot C
3 Card in slot D
Note:
refer to 4.4.1 SY command
AR-3000SD (Ver.1.00) Command Reference - 56
