175
Recording/Playing Back What You Play
Recording/Playing Back What You Play
Here’s how to play back a performance you’ve recorded.
fig.07-08-2.eps*
1.
Touch <Rec/Play> on the Main screen.
fig.05-08.eps
The Rec/Play screen appears.
fig.07-04-2.eps
2.
Touch <Reset>.
The location at which playback will start will return to the
beginning of measure 1.
If you wish to begin playback from the middle of the
song, touch <Bwd> <Fwd> to move to the measure from
which you wish to begin playback.
3.
Touch <Play> to begin playback.
After playback reaches the end of the performance, it
will stop automatically.
You can also begin playback by pressing the Composer
[Play/Stop] button.
4.
To stop playback at any point, touch <Stop>.
You can also stop playback by pressing the Composer
[Play/Stop] button.
The Play and Stop functions can both be assigned to one of
the foot switches located on each side of the Expression
Pedal (p. 134).
You can specify whether or not the Expression Pedal will
affect the playback and what you play while ATELIER music
file is being played back (p. 212).
If you load performance data (such as SMF music files) that
was not designed for an ATELIER Series instrument and play
it back, you may find, when playing Rhythms and Automatic
Accompaniment, that the music doesn’t sound quite like it
should (For example, the wrong sounds could be played). If
you want the data to be played back accurately, first press
the [Reset] button prior to playback.
In cases such as when you want to perform in time with a
song, you can have a count sound played before playback of
the song begins, allowing you to synchronize your own
performance with the song.
Playing back a song after playing the count sound is called
“Count In.”
1.
Hold down the [Reset] button and press the
[Play/Stop] button.
The metronome will play two measures (bars) of count-in
before recording begins.
Playing Back a Performance
Song
Add a Count Sound to Match
the Timing (Count In)
NOTE
AT-800_e.book 175 ページ ２００８年１０月１５日 水曜日 午前９時３７分
