Playing the BK-5’s real-time parts
24
r
Backing Keyboard
BK-5
7.
Playing the BK-5’s real-time parts
Your BK-5 contains three real-time parts that can be controlled via MIDI: UP1, UP2 and LWR. Feel free to use only UP1 or
to control all three simultaneously. You can assign the desired sounds (or “Tones”) to each of these parts. See page 119
for a list of the available sounds.
Switching the UP2 and LWR parts
on and off
The UP1 part is always active. The UP2 and LWR parts,
however, can be switched on or off.
1.
Press the [UP2] or [LWR] button to switch
the corresponding part (Upper2 or Lower)
on (indicator lights) or off (indicator goes
dark).
If you switch on one of these parts, the cursor on the
main page automatically jumps to the “UP2” or
“LWR” field. If [UP2] and [LWR] are both switched off,
the cursor jumps to the “UP1” field.
Selecting Tones for the real-time
parts
On the BK-5, the sounds you can assign to the real-time
parts are called “Tones”. The BK-5 allows you to assign
any of the available Tones to any of the three real-time
parts. Tone selection always applies to the part (UP1,
UP2, or LWR) whose field is currently displayed in
reverse.
Tones can be selected in two ways:
Using the [UP2] or [LWR] button to select Tones
1.
Press and hold the [UP2] or [LWR] button.
The display now shows a list of Tones where the cur-
rently selected sound is displayed in reverse:
2.
If the Tone you need belongs to another
family (see p. 119), press another Tone but-
ton.
3.
Rotate the [CURSOR
÷
VALUE] dial to select
the desired Tone, then press the [ENTER/
SELECT] button to confirm your selection.
4.
Press [EXIT] to leave the Tone selection
page.
NOTE
You can only listen to Tones for the Upper2 or Lower part if
the [UP2] or [LWR] button lights.
NOTE
Tones can also be selected by simply pressing the
[NUMERIC] key and entering their number.
Selecting a Tone on the main page
1.
If the main page is not displayed, press and
hold the [EXIT] button until it appears.
The numbers and names of the Tones assigned to the
three real-time parts are displayed in the lower half
of the display:
The highlighted numeric field refers to the part
whose Tone assignment can be changed. To select a
different part, move the cursor to its numeric field
and press the [ENTER/SELECT] button.
2.
Rotate the [CURSOR
÷
VALUE] dial to select
the desired numeric field, then press the
[ENTER/SELECT] button.
BK-5_US.book Page 24 Monday, November 14, 2011 12:43 PM
Summary of Contents for BK-5
Page 1: ...r Owner s Manual BK 5_US book Page 1 Monday November 14 2011 12 43 PM ...
Page 148: ...Index 148 rBacking Keyboard BK 5 BK 5_US book Page 148 Monday November 14 2011 12 43 PM ...
Page 150: ...150 rBacking Keyboard BK 5 MEMO BK 5_US book Page 150 Monday November 14 2011 12 43 PM ...
Page 152: ...r 602 00 0527 01 RES 873 11 BK 5 OM E BK 5_US book Page 152 Monday November 14 2011 12 43 PM ...
