Roland BOSS OD-200, Owner'S Manual

8

Saving to Memory

Here's how to save effect settings that you edited.

1. 

Long-press the [MEMORY] button.

The display indicates “

Wrt

.”

2. 

Turn the [PARAM] knob to select the save-
destination (MAN, 1–127).

You can also select the save-destination by pressing 
the [MEMORY] button.
If you decide to cancel, press the [PARAM] button.

3. 

Long-press the [MEMORY] button to confirm 
the save-destination.

The memory is saved.

*  If you save to MAN, the settings of the panel are applied as the 

values for MODE, DRIVE, LEVEL, LOW, MIDDLE, and HIGH.

Switching Memories

Here’s how to recall a saved memory.

1. 

Press the [MEMORY] button to select a 
memory.

Each time you press the button, you cycle through 
the memories in the order of “MAN (manual) 

0

 1 

0

 2 

0

 3 

0

4 ...127

0

 MAN...”

You can also switch memories by holding down the 
[MEMORY] button and turning the [PARAM] knob.

*  The MEMORY indicator is unlit if a memory 5–127 is selected.

MEMO

You can specify the memory switching range by editing 

the 

ETF

(EXTENT FROM)

 and 

ETT

(EXTENT TO)

 settings (p. 11).

What is “MAN” (manual)?

This unit normally applies the effect according to the 

settings that are saved in memory, but if you select 

MAN (manual) the effect is applied according to the 

positions of the panel knobs. Even in this case, the 

booster and gate settings recall the settings that are 

written to MAN (this can be changed).

Saving and Switching Memories