16
Dec. 2005
RT-20
8.
Confirm the output waveform will be like the following picture.
fig.06-ANABYP-3_70(200 mV/DIV, 1 ms/DIV)
<< 200Hz, 500 mV p-p +/-40 mV p-p >>
9.
Input the 200 Hz/500 mV p-p rectangular wave to both INPUT A
(MONO) and INPUT B.
10.
Confirm the output waveform will be like the following picture.
fig.06-ANABYP-1_70(200 mV/DIV, 1 ms/DIV)
<< 200Hz, 500 mV p-p +/-40 mV p-p >>
7. Analog Bypass Route FET Switch
Check
1.
Press the right pedal to start the
Analog Bypass Route FET Switch
Check
.
fig.07-ANASW-panel
2.
Confirm the output wave disappears and the following picture appears.
fig.07-ANASW-1_70(200 mV/DIV, 1 ms/DIV)
<< 200Hz, 500 mV p-p +/-40 mV p-p >>
8. D/A Output Waveform Check
1.
Press the right pedal to start the
D/A Output Waveform Check
.
fig.08-DA-panel
2.
Connect an oscilloscope to OUTPUT A (MONO) and OUTPUT B.
(Or confirm they have been connected.)
3.
Confirm the output waveform will be like the following picture.
fig.08-DA-1_70(200 mV/DIV, 1 ms/DIV)
<< 400Hz, 500 mV p-p +/-40 mV p-p >>
4.
Remove the connection of OUTPUT B.
200mV/DIV, 1ms/DIV
200mV/DIV, 1ms/DIV
200mV/DIV, 1ms/DIV
200mV/DIV, 1ms/DIV
Summary of Contents for BOSS RT-20
