Roland Camm-1 Pro GX-640, User Manual

17

5

ABOUT THE CUTTING AREA

6

USING THE DISPLAY MENUS

This section describes the basic steps for using the display menus.  Use this information together with "7 Display Menu Flowchart" on
the following page to make menu settings.

AREA    AXIS

REPLOT  SUBMENU

1 CUT    50cm/S

0.250      30gf

MENU

ENTER

ENTER

Press the             key to change to 
the next menu

AREA      LENGTH

MOVE      <1.0m>

ROTATE      

<0deg>    90deg

ENTER

Then use the     and     keys to change the value and
enable the setting by pressing the             key 

Use the     and     keys to move the 
blinking cursor ("   ") and choose a setting  

Press the             key to advance

to the next setting screen

Select "AREA"

The value enclosed in angled brackets ("<>") is the current setting

The selection enclosed in angled brackets ("<>") is the current setting

MENU

Use the     and     keys to move the blinking cursor ("   ") and choose a setting.  
Then use the     and     keys to change the value (or the selection) and enable the setting by pressing the             key.

Use the     and     keys to move the blinking cursor 
("   ") and choose a setting  

• To return to the menu selection screen from any of the menu

value setting screens, press the  

MENU

 key.

• To return to the previous screen without changing the numerical

settings, pressing the 

MENU

 key without pressing the 

ENTER

key.

* The pairs of allows

indicate the positive
direction along the X
and Y axis.

Acceptable material widths

PNC-1860 : 90—1372 mm   (3-1/2"—54" )
PNC-1410 : 90—1067 mm   (3-1/2"—42" )
PNC-1210 : 50—762 mm     (1-15/16"—30" )

The cutting area along the horizontal plane (the direction in which the tool carriage moves) is determined by the position of the pinch
rollers. The workable area spans the length between the two rollers, minus a margin of about 1 mm (about 0.04") on both sides.
If the material length is greater than 1,600 mm (62-15/16") when a flat material (paper) has been loaded, the PNC-1860/1410/
1210 determines it to be a rolled material and sets the material length to 24,998 mm (984-1/8").

Maximum cutting area

PNC-1860 : 1195 mm (W) x 24998 mm (L)

(47" x 984-1/8")

PNC-1410 : 889 mm (W) x 24998 mm (L)

(35" x 984-1/8")

PNC-1210 : 585 (W) mm x 24998 mm (L)

(23" x 984-1/8")

PNC-1860

PNC-1410

PNC-1210

1195 mm (47")

889 mm (35")

585 mm (23")

24998 mm (984-1/8")

10 mm
(3/8")

Approx. 1 mm
(about 0.04")

Cutting coordinates origin (0,0)

Movable pinch roller (left)

Cutting area

Sheet

Movable pinch roller (right)

Approx. 15 mm
(about 9/16")