22
[90
°
Rotation]
Y
X
Y
X
[0
°
Rotation]
2 ROTATE
Whenever you employ the Rotate function (which allows you to rotate a character 90 degrees), the origin will be located at the
material’s lower-right.
1 OVER CUT
Cutting results differ as shown in the following figures depending on whether the Overcut function is on or off.
MENU
Explanation
Default
Page where
explained
Giving priority to settings from the computer
TOOL-CNG
COMMAND
This is normally set to "IGNORE" when performing cutting. When a
tool-selection instruction (SP instruction) is sent from the computer
while this is set to "EGNORE," the SP instruction is ignored and
operation continues without pause. When set to "EFFECT," SP exchange
instructions are accepted and operation pauses. If tool change is needed,
open the front cover, change the tool, then press the ENTER key.
IGNORE
23, 24
VS
COMMAND
To perform cutting at the speed determined by a VS command (tool speed
setting command) sent from the computer, set this to "EFFECT." When
set to "IGNORE," cutting is performed using the values for "** cm/s" and
"UPSPEED" set at the top menu.
IGNORE
1 1
FS
COMMAND
To perform cutting at the tool force determined by an FS command (tool
force setting command) sent from the computer, set this to "EFFECT."
When set to "IGNORE," cutting is performed using the values for "** gf"
set at the top menu.
IGNORE
1 1
Other setting
ENGLISH,
JAPANESE,
GERMAN,
F R E N C H
SPANISH,
ITALIAN
The PNC-1860/1410/1200 is capable of displaying all its menus in
either of six languages, English, French, German, Spanish, Italian
and Japanese.
ENGLISH
-
UNIT
This sets the type of unit for coordinate values that appear on the display.
Set this to “MECHANICAL UNIT” for display in cutting coordinate units
(1 = 0.025 mm), or to “MILLIMETER” for display in millimeters.
MACHINE
-
DEMO CUT
This performs an operation check when the PNC-1860/1410/1210 is not
working correctly.
-
-
UP/DOWN
MOVE
This moves the tool up or down. It also moves the tip of the blade in any
of four directions (-X, +X, -Y, or +Y).
With the tool down, the tool carriage can be moved with the four cursor
keys to cut the sheet.
-
-
OVER CUT: OFF
OVER CUT: ON
Origin
Origin
Summary of Contents for Camm-1 Pro GX-640
Page 8: ...v MEMO...
Page 38: ...30 Automatic backspace 13 CHARACTER SET...
Page 41: ...R9 980506...
