Roland Camm-1 Pro GX-640, User Manual

26

11 WHAT TO DO IF....

11-1  What to do if....

PNC-1860/1410/1210 troubleshooting

Is the power cord connected correctly?

Connect the power cord included with the PNC-1860/1410/1210 to the unit, 
and plug the other end securely into an electrical outlet (see “3-1 
Installation and Connections” on page 3).

Is the PNC-1860/1410/1210 power on ?

Turn on the power.

Is the front cover closed?

Close the front cover when performing cutting (see “3-3 Loading a Sheet” 
on page 5).

Is the PNC-1860/1410/1210 in the temporary 
halt state ?   Is operation paused?

If the screen shown at rights is displayed, 
it means that operation is paused.
Follow the steps described in " Pausing Cutting"
To resume cutting, use the       and        keys to select "CONT," then press the   
key.To abord cutting, first stop the flow of cutting instructions from the 
computer. And use the       and        keys to select "STOP," then press the        
key.

If connected via the serial port, do the 
communication parameters for the PNC-
1860/1410/1210 match those of the 
computer ?

At the display menus, make the correct settings for the communication 
parameters (refer to “3-4  Selecting the Interface” on page 11).

Is the computer set up correctly ?

Check the following items:
• DIP switches      • Memory switches     • Interface board     • Communication 
parameters      • Other settings
Read the computer user’s manual and set it up correctly.

Are the computer and the PNC-1860/1410/
1210 linked with the right cable ?

The type of cable you need  is determined by your computer and the software 
you are using. Even if the computer is the same, running different software 
may require a different cable. Use the cable specified in your software.

Are the computer and the PNC-1860/1410/
1210 connected correctly?

Correctly connect the computer and the PNC-1860/1410/1210 (see “3-1 
Installation and Connections” on page 3).

Is the interface setting correct?

At the display menu, make the correct setting for the interface connecting 
the computer and the PNC-1860/1410/1210 (refer to “3-4 Selecting the 
Interface” on page 11).

Is the OS set up correctly ?

Check the following items:
•  Output port selection     •  Output device selection     •  Output port open  
•  Communication Parameters     •  Other settings
Check the OS’s user’s manual and set it up correctly.

Are the application software settings 
correctly ?

Check the following items:
•  Output device specifications (select a device name that matches the 
instruction system. 
If the wrong device is  selected an incorrect instruction may be output, 
resulting in an error).
•  Communication Parameters  •  Other settings
Check the software user’s manual and set it up correctly.

PAUSE ON
CONT. STOP VIEW

ENTER