3 Replacement of Main Parts
19
3
3 Replacement of Main Parts
Following table describes the necessary adjustment after the replacement of each parts.
3-1 HEAD CARRIAGE ASSEMBLY_QUICK REPLACEMENT
1
Remove the RAIL COVER and disconnect the HEAD
CABLEs connected to CARRIAGE BOARD.
This section explains the procedure for replacing the HEAD CARRIAGE simply and efficiently.
Therefore, there are some screws on the HEAD CARRIAGE which should not be touched. In case
you have touched this screw, fix the HEAD CARRIAGE by refering to 3-2 HEAD CARRIAGE
ASSEMBLY_REPLACEMENT.
Replacement Parts
Necessary Adjustment
MAIN BOARD
Initialization, Head Voltage Adjustment, Cartridge Position Adjustment, Print/Cut
Offset Adjustment, Tool Pressure, Grit Compensation, Thermal Head Density
Adjustment
HEAD CARRIAGE
Head Voltage Adjustment, Head Density Adjustment, Cartridge Position
Adjustment, Head Position Adjustment, Print/Cut Offset Adjustment, Printed Length
Initialization
TOOL CARRIAGE
Tool Height Adjustment, Tool Pressure Adjustment, Print/Cut Offset Adjustment
CARTRIDGE HOLDER
Cartridge Position Adjustment
WIRE
Wire Tension Adjustment
Summary of Contents for Color Camm Pro PC-60
Page 4: ... MEMO ...
Page 6: ...2 1 Structure Spare Parts 1 1 2 FRAME 1 ...
Page 8: ...4 1 Structure Spare Parts 1 1 3 FRAME 2 ...
Page 88: ...84 4 Adjustment 4 MEMO ...