65
4 Adjustment
4
4-13 PRINT/CUT OFFSET ADJUSTMENT
1
Raise the SHEET LOADING LEVER.
[PRINT/CUT OFFSET ADJUSTMENT MODE FLOW CHART (in Factory Mode)]
PRINT/CUT OFFSET ADJUSTMENT is designed to ensure the relation of printing and cutting position.
This adjustment must be performed after replacement of the TOOL CARRIAGE, HEAD CARRIAGE and
MAIN BOARD. It is necessary to enter the PRINT/CUT OFFSET ADJUSTMENT MODE in the
FACTORY MODE to perform this adjustment.
[POWER] LED will blink and
[PIECE] & [ROLL] LED will be ON.
Set media and
ribbon cartridge.
PRINT/CUT OFFSET ADJUSTMENT MODE
Save Settings.
[SEET TYPE] key
[POWER] key
After all [CARTRIDGE HOLDER] LED
become ON, it will be turned OFF from 1 to 6 in order.
Then, [PIECE] and [ROLL] LED will be ON.
CROP MARK will
be printed.
Adjust PRINT/CUT
OFFSET.
[ ], [ ], [ ] and [ ] keys
[POWER] key
[POWER] LED will be ON and
[PIECE] or [ROLL] LED will blink.
Summary of Contents for Color Camm Pro PC-60
Page 4: ... MEMO ...
Page 6: ...2 1 Structure Spare Parts 1 1 2 FRAME 1 ...
Page 8: ...4 1 Structure Spare Parts 1 1 3 FRAME 2 ...
Page 88: ...84 4 Adjustment 4 MEMO ...
