72
4 Adjustment
4
4-16 GRIT COMPENSATION
[GRIT COMPENSATION MODE FLOW CHART (in Factory Mode)]
1
Make sure to check the followings before this adjustments.
1. Put LINE SPACING MODE to default. (P.95)
2. Put the GRIT ECCENTRICITY ADJUSTMENT to
default.
GRIT COMPENSATION is designed to ensure the distance accuracy by adjusting the media-feeding rate.
This adjustment must be performed after replacement of the MAIN BOARD, or in case of having GAP
between BANDs or BANDING PROBLEM, or in case you like to improve the distance accuracy.
It is necessary to enter the GRIT COMPENSATION MODE in the FACTORY MODE to perform this
adjustment.
PRINTING MODE
[POWER] LED will blink and
[PIECE] & [ROLL] LED will be ON.
Test pattern for GRIT
COMPENSATION will
be printed.
GRIT COMPENSATION
MODE
ADJUSTMENT MODE
Save Settings.
[POWER] key
[ ] or [ ] keys
[SHEET TYPE] key
After all [CARTRIDGE HOLDER] LED
become ON, it will be turned OFF from 1 to 6 in order.
Then, [PIECE] and [ROLL] LED will be ON.
Change parameters
for GRIT
COMPENSATION.
Indicates setting by
LED.
Change parameters
to default.
[CUT TEST] key
[BASE POINT] key
[ ] or [ ] keys
Summary of Contents for Color Camm Pro PC-60
Page 4: ... MEMO ...
Page 6: ...2 1 Structure Spare Parts 1 1 2 FRAME 1 ...
Page 8: ...4 1 Structure Spare Parts 1 1 3 FRAME 2 ...
Page 88: ...84 4 Adjustment 4 MEMO ...
