8
4 Basic Operation
Roll material must be placed at a
predetermined shaft position.
Failure to do so
may result in
falling of the roll,
leading to injury.
4-1 Loading the Material (Roll Material)
Acceptable Material Width and Maximum Cutting Width
Acceptable material widths
Maximum cutting area
CX-500
Min.90 mm (3-1/2 in.) Max.1372 mm (54 in.)
1195 mm (47 in.)
CX-400
Min.90 mm (3-1/2 in.) Max.1178 mm (46 in.)
1000 mm (39 in.)
CX-300
Min.50 mm (2 in.) Max.915 mm (36 in.)
737 mm (29 in.)
( 50 to 540 mm (2 in. to 21 in.) , 582 to 915 mm (23 in. to 36 in.) )
There is no special restriction on length (vertical dimension), as long as it is 200 mm (7-7/8 in.) or more.
You can also use flat material such as standard-size and piece material. For more information, see “5-4 Loading Flat Material
(Standard-size Material, Piece Material, Etc.).”
The grit rollers (pinch rollers that secure the material) vary from one model to another, and settable ranges are determined for the left
and right movable pinch rollers. See “Material Loading Position” on the following page.
Setting a pinch roller outside the allowed range causes an error message to appear.
To cut off a piece of material with the separating knife, load the media within the range shown below.
Loading media outside this range may make it impossible to cut off the material with the separating knife.
13 mm (1/2 in.) from the edge
of the leftmost grit pattern
37 mm (1-7/16 in.) from the edge
of the Rightmost grit pattern
Separable range
Summary of Contents for CX-300
Page 21: ...21 POWER ERROR LED goes out 4 Turn off the power ...
Page 63: ...63 MEMO ...
Page 64: ...R5 020403 ...
