5
Set up
1.
Use a commercially available drum key to tighten
the stopper bolt.
The stopper keeps the V-Cymbal from turning, and prevents
the cables from catching or getting tangled on the stand.
fig.04.e.eps
2.
Position the Roland logo on the farther side, as
viewed from the performer.
3.
Tighten the felt washer and the wing nut to obtain
the desired movement.
fig.05.e.eps
4.
Secure the cables in place with the cable tie, while
leaving some slack in the cables to ensure that they
are not pulled by the movement of the cymbal
units when struck.
fig.06.e.eps
* Take care to ensure that the cables do not touch the cymbal units and/
or the stand. A cable touching a cymbal unit or a stand may cause
double sounding or other incorrect operation.
* Double sounding may occur if the wing nut is loose.
* Use the included felt washer and wing nut.
* To prevent malfunction and/or damage to speakers or other devices,
always turn down the volume, and turn off the power on all devices
before making any connections.
Use the supplied connection cables (stereo) to make the
connections. If monaural cables are used, edge shots, bell
shots, and choke play cannot be supported.
Connect the L-shaped plug of the included cable to the CY-
15R/14C.
The CY-14C has no BOW/BELL output. Make the connection
to the BOW/EDGE output.
fig.08.eps
The CY-15R can take advantage of your drum sound
module’s three-way triggering functionality to allow you to
play bow, bell, and edge separately.
Connect the two outputs BOW/BELL and BOW/EDGE to the
drum sound module at the same time.
For details on the connection method and settings, refer to
the owner’s manual for your drum sound module.
* If you won’t be using the three-way triggering functionality, connect
either the BOW/BELL output or the BOW/EDGE output (not both) to
your drum sound module.
Mounting on the Stand
Stopper
(Be sure to orient
it correctly)
Tighten the bolt with a
commercially available
drum key
Position the Roland logo
on the opposite side of
the playing area
Felt Washer
Wing Nut
Tighten it
not to slip
Wind the
cable tie
twice
Leave some
slack in the
cable(s)
Turn back to
fix the cable(s)
Connecting to a Sound Module
About three-way triggering (CY-15R only)
Ride
CY-15R
Crash
CY-14C
RIDE
EDGE
CRASH
Set Up Example : Connecting to the TD-20
TD-20 Rear Panel
BOW / BELL
Output Jack
BOW / EDGE
Output Jack
CY15R14C_e.fm 5 ページ ２００９年２月２３日 月曜日 午後６時５８分
