Roland CY-8, Owner'S Manual

10

KD-8

Connecting to a Percussion Sound 
Module

1.

Use the included connection cable and connect 

the output jack of the KD-8 to the trigger input 

jack of the percussion sound module.

Connect the L-shaped plug of the included cable to the 
KD-8. This will prevent strain from being applied to the 
KD-8.

2.

Make the trigger settings for the percussion 

sound module. For the recommended values, 

refer to p. 12.

Should you neglect to make the appropriate settings for 

the percussion sound module, you could likely experience 

the following problems:

• Sometimes it does not sound (uneven volume)
• The volume is too low (reduced sensitivity)

For information on how to change the parameters for a 
percussion sound module, refer to the documentation for 
the percussion sound module you’re using.

Specifications

KD-8: Kick Trigger Unit

Dimensions:

272 (W) x 260 (D) x 405 (H) mm
10-3/4 (W) x 10-1/4 (D) x 16 (H) inches

Weight:

2.9kg / 6 lbs 7 oz

Accessories:

Owner’s Manual, Connection Cable, Screws

962a

In the interest of product improvement, the specifications 
and/or appearance of this unit are subject to change without 
prior notice.

PD/CY/KD/FD-8_e 10 ページ ２００７年７月２０日　金曜日　午前９時４５分