22
Dec.2004
5. Piezo check
fig.piezo.eps
With your finger, lightly strike the pad [RIDE [20, B]] of the DR-880; the
“VALUE” in the LCD will change.
“PEAK” will indicate the peak-hold value.
Gradually increase the force of your strikes until PEAK indicates “OK.”
fig.piezocheck2.eps
Verify that PEAK indicates OK.
Press [BANK] to proceed to the next test item.
6. Volume check
6-1. Guitar/bass input VR check
fig.volumecheck1.eps
Set the GUITAR/BASS INPUT VR to the center position.
fig.volumecheck2.eps
The result will be NG if you move any other volume control.
In this case, set all knobs to the maximum position, and then press the [TSC]
switch to resume from the GUITAR/BASS INPUT VR check.
fig.volumecheck3.eps
Set the GUITAR/BASS INPUT VR to the minimum position.
fig.volumecheck4.eps
Set the GUITAR/BASS INPUT VR to the maximum position.
fig.volumecheck5.eps
6-2. Drum VR check
Perform the same test for the DRUM VR. (maximum -> center -> minimum ->
maximum)
fig.volumecheck6.eps
6-3. Bass VR check
Perform the same test as you did for the BASS VR. (maximum -> center ->
minimum -> maximum)
fig.volumecheck7.eps
*
If desired, you can set all knobs to the maximum position and then press the
[TSC] and resume from the GUITAR/BASS INPUT VR check.
Verify that all VR tests are successfully completed (all OK).
Press [BANK] to proceed to the next test item.
7. Foot Switch check
fig.footswcheck1.eps
Summary of Contents for DR-880
