18
Mar.2001
SP-303
ABOUT THE SHAPING OF THE
WIRING
After disassembling the SP-303 for replacing the basal board and when hearing
a noise in [10. NOISE CHECK] in [Return to test mode & factory shipment
condition], always shape the ribbon cable 1-4 (P/No.02671167, 02671178,
02671189, 02671190) as described in the figure below.
*
When hearing a noise in [10. NOISE CHECK], assemble referring to [2.
RIBBON CABLE 13P (P/NO. 02671167) shaping method].
fig.ribon
1.RIBON CABLE 5P (P/No.02671190)
2.RIBON CABLE 14P (P/No.02671189)
3.RIBON CABLE 13P (P/No.02671178)
4.RIBON CABLE 11P (P/No.02671167)
1.RIBON CABLE 5P (P/
No.02671190) shaping method
Bend the SW board (P/No. 71785956) and RIBBON CABLE 5P (P/
No.02671190) vertically and make a fold line by bending to the center of
RIBBON CABLE 5P.
fig.ribon11
1.
Bend the ribbon cable vertically.
2.
Bend at the center between main board and SW board.
Centralizing the fold line in the center, pick about 2 cm by finger and press
down the part of RIBBON CABLE 5P which was picked by the finger next to
the line terminal.
(At this time, make sure the RIBBON CABLE 5P between the SW board and
the center fold line goes over the BOSS of the top case.)Åj
FIG12.eps
1.
Make a fold line by bending for about 2 cm.
2.
Press down to the direction of the arrow.
FIG13.eps
FIG14.eps
1.BOSS
2.Step over the BOSS.
*
When fastening after building the body, the screw hole of the bottom cover may
get covered with the cable when the RIBBON CABLE 5P and BOSS run in to
each other.
When building up, fit the top case and bottom cover by adjusting the RIBBON
CABLE 5P position.
BOSS
Summary of Contents for Dr. Sample SP-303
