25
Getting Connected and Installing Drivers (Windows)
Windows Me/98 users
1
With the PCR-1 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse (if
used).
If you are using virus checking or similar software, be sure to exit it as well.
2
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar
software, be sure to exit it as well.
3
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
4
Click the Windows
Start
button. From the menu that appears, select
Run...
.
The
“Run...”
dialog box will appear.
fig.05-13_30
5
In the dialog box that appears,
input the following into the
“Open”
field, and click
[OK]
.
(drive name) : \Driver\USB_ME98\SETUPINF.EXE
The
SetupInf
dialog box will appear.
You are now ready to install the driver.
* In the explanatory example shown here, the drive name is given as
“D:”
. The drive
name
“D:”
may be different for your system. Specify the drive name of your CD-
ROM drive.
6
Use the
USB cable
to connect the
PCR-1
to your
computer
.
The driver will be installed automatically.
7
In the SetupInf dialog box, click
[OK]
.
To check the drive name
In the Windows desktop,
double-click the
My
Computer
icon. In the
window that appears,
check the drive name of
the CD-ROM drive into
which you inserted the
CD-ROM in step3.
The drive name is the (D:)
or (E:) displayed by the
CD-ROM drive
.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after connecting the USB
cable is required before the
unit will operate normally.
If a message recommends
that you restart Windows,
restart Windows as
directed.
Next, make MIDI device and audio device settings.
(
Specifying the audio and MIDI input/output destination
PCR-1_e1.book 25 ページ ２００３年１１月２０日 木曜日 午後３時２２分
Summary of Contents for Edirol PCR-1
Page 98: ...98 MEMO PCR 1_e1 book 98...
